User Manual
Table Of Contents
- TSS-4100 Integrated TCAS, Transponder, and ADS-B Traffic Surveillance System
- TITLE PAGE
- LIST OF EFFECTIVE PAGES
- TABLE OF CONTENTS
- LIST OF ILLUSTRATIONS
- LIST OF TABLES
- INTRODUCTION
- SAFETY SUMMARY
- 1 General Information
- 2 System Components
- 2.1 INTRODUCTION.
- 2.2 COMPONENT DESCRIPTIONS.
- 2.3 ANT-42 34-54-00.
- 2.4 L-BAND ANTENNA, ANT-42, DATA.
- 2.5 ECU-3000 34-54-00.
- 2.6 EXTERNAL CONTROL UNIT , ECU-3000, DATA.
- 2.7 TDR-94D 34-54-00.
- 2.8 MODE S TRANSPONDER, TDR-94D, DATA.
- 2.9 TRE-930 34-54-00.
- 2.10 ANTENNA, TRE-930, DATA.
- 2.11 TSA-4100 34-54-00.
- 2.12 ANTENNA, TSA-4100, DATA.
- 2.13 TSS-4100 34-43-00.
- 2.14 TRAFFIC SURVEILLANCE SYSTEM, TSS-4100, DATA.
- 3 Operation
- 4 Maintenance
- 4.1 INTRODUCTION.
- 4.2 MAINTENANCE SCHEDULE.
- 4.3 CONVERSION FROM TTR/TDR TO TSS SYSTEM.
- 4.4 DATA LOADING.
- 4.5 TSS-4100 MODE S ADDRESS PROGRAMMING TOOL.
- 4.6 LED INDICATORS.
- 4.7 TEST EQUIPMENT AND POWER REQUIREMENTS.
- 4.8 TESTING AND TROUBLESHOOTING.
- 4.8.1 Pre-installation Testing.
- 4.8.2 TCAS Self Test.
- 4.8.3 Equipment Setup.
- 4.8.4 Radio Altitude System Failure Tests.
- 4.8.5 Pressure Altitude System Failure Tests.
- 4.8.6 Range and Bearing Test.
- 4.8.7 TCAS RA Test.
- 4.8.8 Transponder Tests.
- 4.8.9 ADS-B Transmit Ground Test.
- 4.8.10 Transponder/TCAS Suppression Bus Issues.
- 4.9 INITIAL INSTALLATION CHECK OUT PROCEDURE.
- 4.10 RETURN TO SERVICE TEST PROCEDURE.
- 4.11 INSPECTION/CHECK.
- APPENDIX A Faults and Warnings
- APPENDIX B Maintenance Words
- APPENDIX C Buses and Other Interfaces
- APPENDIX D Equipment Characteristics
- APPENDIX E Interconnect Diagram
- BACK COVER
appendix B 523-0 809018
B.1.5. Label 354 TSS-4100 Diagnostic Word 3.
Refer to Table B-7 for the definition of this word and a possible solution to the indicated issue.
Table B-7. Label 354 TSS-4100 Diagnostic Word 3
Bit Label 354- TSS-4100 Diagnostics Word 3 Possible S olution
9SDI*
10 SDI*
11 LMP - 1C/D (Control A ) (Active = 0 Inactive = 1) Check wiring from appropriate controller to the TSS.
Repair wiring or replace the appropriate unit.
12 LMP - 6G/H (GPS #1) (Active = 0 Inactive = 1) (Optional connection) Check wiring from the onside G PS.
Repair wiring or replace the GPS.
13 LMP - 7C/D (Control B) (Active = 0 Inactive = 1) Check wiring from appropriate controller to the TSS.
Repair wiring or replace the appropriate unit.
14 LMP - 7E/F (ADS-B #1) (Active = 0 Inactive = 1)
15 LMP - 7G/H (ADS-B #2) (Active = 0 Inactive = 1)
16 LMP - 7J/K (Data Load) (Active = 0 Inactive = 1)
17 LMP - 8G/H (IAPS #1) (Active = 0 Inactive = 1) Check wiring from the onside I/O Concentrator. Repair
wiring or replace the concentrator.
18 LMP - 8J/K (CMU #1) (Active = 0 Inactive = 1)
19 RMP - 1C/D (Control C) (Active = 0 Inactive = 1) (Optional connection) Check wiring from appropriate
controller to the TSS. Repair wiring or replace the
appropriate unit.
20 RMP - 2G/H (GPS #2) (Active = 0 Inactive = 1) (Optional connection) Check wiring from the cross-side
GPS. Repair wiring or rep lace the GPS.
21 RMP - 7C/D (A768) (Active = 0 Inactive = 1)
22 RMP - 8G/H (IAPS #2) (Active = 0 Inactive = 1) Check wiring from the cross-side I/O Concentrator.
Repair wiring or replace the concentrator.
23 RMP - 8J/K (CMU #2) (Active = 0 Inactive = 1)
24 RMP - 8A/B (XT #2) (Active = 0 Inactive = 1) Check both the XT and TX bus w iring; check to see if off
side TD R is working properly.
25 to 29 Pad
30 SSM**
31 SSM**
32 Odd Parity
*SDI Code: Bit 10 Bit 9 LRU Number **SSM Code: Bit 31 Bit 30 LRU Status
00NotUsed 00Normal
01Left 01NotUsed
10Right 10Test
1 1 Not Used 1 1 Not Used
B-11