User Manual
Table Of Contents
- TSS-4100 Integrated TCAS, Transponder, and ADS-B Traffic Surveillance System
- TITLE PAGE
- LIST OF EFFECTIVE PAGES
- TABLE OF CONTENTS
- LIST OF ILLUSTRATIONS
- LIST OF TABLES
- INTRODUCTION
- SAFETY SUMMARY
- 1 General Information
- 2 System Components
- 2.1 INTRODUCTION.
- 2.2 COMPONENT DESCRIPTIONS.
- 2.3 ANT-42 34-54-00.
- 2.4 L-BAND ANTENNA, ANT-42, DATA.
- 2.5 ECU-3000 34-54-00.
- 2.6 EXTERNAL CONTROL UNIT , ECU-3000, DATA.
- 2.7 TDR-94D 34-54-00.
- 2.8 MODE S TRANSPONDER, TDR-94D, DATA.
- 2.9 TRE-930 34-54-00.
- 2.10 ANTENNA, TRE-930, DATA.
- 2.11 TSA-4100 34-54-00.
- 2.12 ANTENNA, TSA-4100, DATA.
- 2.13 TSS-4100 34-43-00.
- 2.14 TRAFFIC SURVEILLANCE SYSTEM, TSS-4100, DATA.
- 3 Operation
- 4 Maintenance
- 4.1 INTRODUCTION.
- 4.2 MAINTENANCE SCHEDULE.
- 4.3 CONVERSION FROM TTR/TDR TO TSS SYSTEM.
- 4.4 DATA LOADING.
- 4.5 TSS-4100 MODE S ADDRESS PROGRAMMING TOOL.
- 4.6 LED INDICATORS.
- 4.7 TEST EQUIPMENT AND POWER REQUIREMENTS.
- 4.8 TESTING AND TROUBLESHOOTING.
- 4.8.1 Pre-installation Testing.
- 4.8.2 TCAS Self Test.
- 4.8.3 Equipment Setup.
- 4.8.4 Radio Altitude System Failure Tests.
- 4.8.5 Pressure Altitude System Failure Tests.
- 4.8.6 Range and Bearing Test.
- 4.8.7 TCAS RA Test.
- 4.8.8 Transponder Tests.
- 4.8.9 ADS-B Transmit Ground Test.
- 4.8.10 Transponder/TCAS Suppression Bus Issues.
- 4.9 INITIAL INSTALLATION CHECK OUT PROCEDURE.
- 4.10 RETURN TO SERVICE TEST PROCEDURE.
- 4.11 INSPECTION/CHECK.
- APPENDIX A Faults and Warnings
- APPENDIX B Maintenance Words
- APPENDIX C Buses and Other Interfaces
- APPENDIX D Equipment Characteristics
- APPENDIX E Interconnect Diagram
- BACK COVER
appendix C 523-0 809018
C.3. TSS DISCRETE INPUTS.
Refer to Table C-3 for a list of the discrete inputs to the TSS and their expected connections .
Table C-3. TSS Discrete Inputs
Pin Name Conn Pin Expected Connection /Notes
XTDR Active (from XTDR) LMP 2J Cross side transponder
Extended Squitter Disable LMP 2K This will only be connected if there is a switch to turn off
extended squitters
Perf Limit LMP 3E This is an ARINC 735 (TCAS) pin that is not usually used
Simulator Enable LMP 3F Not n ormally connected
Air/Gnd(F) #1 LMP 3G Not normally connected use Air/Gnd #2
Fan Monitor LMP 3K Connect to TSM to monitor fan speed
Air/Gnd(F) #2 LMP 4H Connect to Weight on Wheels indicator
Climb Inhibit #1 LMP 11A This is an ARINC 735 (TCAS) pin that is not usually used
Climb Inhibit #2 LMP 11B This is an ARINC 735 (TCAS) pin that is not usually used
Climb Inhibit #3 LMP 11C This is an ARINC 735 (TCAS) pin that is not usually used
Climb Inhibit #4 LMP 11D This is an ARINC 735 (TCAS) pin that is not usually used
Increase Climb Inh #1 LMP 11E This is an ARINC 735 (TCAS) pin that is not usually used; in
some installations connected to ADC to inhibit increase climbs
at some altitude
Increase Climb Inh #2 LMP 11F This is an ARINC 735 (TCAS) pin that is not usually used; in
some installations connected to ADC to inhibit increase climbs
at some altitude
Increase Climb Inh #3 LMP 11G This is an ARINC 735 (TCAS) pin that is not usually used; in
some installations connected to ADC to inhibit increase climbs
at some altitude
Increase Climb Inh #4 LMP 11H This is an ARINC 735 (TCAS) pin that is not usually used; in
some installations connected to ADC to inhibit increase climbs
at some altitude
Advisory Inhibit #1 LMP 10J Not usually used; puts TCAS into standby
Advisory Inhibit #2 LMP 10K Connect to TAWS or CAS system; puts TCAS into TA only
mode and inhibits all aurals
Advisory Inhibit #3 LMP 11J Connect to TAWS or CAS system; puts TCAS into TA only
mode and inhibits all aurals
Advisory Inhibit #4 LMP 11K Connect to TAWS or CAS system; puts TCAS into TA only
mode and inhibits all aurals
TA Display Valid #1 RMP 10A Usually strapped to ground; for use on TA only display
TA Display Valid #2 RMP 10B Usually strapped to ground; for use on TA only display
RA Display Valid # 1 RMP 10C Connect to pilot side displays
RA Disp lay Valid #2 RMP 10D Connect to co-pilot side displays
C-5