User Manual
Table Of Contents
- TSS-4100 Integrated TCAS, Transponder, and ADS-B Traffic Surveillance System
- TITLE PAGE
- LIST OF EFFECTIVE PAGES
- TABLE OF CONTENTS
- LIST OF ILLUSTRATIONS
- LIST OF TABLES
- INTRODUCTION
- SAFETY SUMMARY
- 1 General Information
- 2 System Components
- 2.1 INTRODUCTION.
- 2.2 COMPONENT DESCRIPTIONS.
- 2.3 ANT-42 34-54-00.
- 2.4 L-BAND ANTENNA, ANT-42, DATA.
- 2.5 ECU-3000 34-54-00.
- 2.6 EXTERNAL CONTROL UNIT , ECU-3000, DATA.
- 2.7 TDR-94D 34-54-00.
- 2.8 MODE S TRANSPONDER, TDR-94D, DATA.
- 2.9 TRE-930 34-54-00.
- 2.10 ANTENNA, TRE-930, DATA.
- 2.11 TSA-4100 34-54-00.
- 2.12 ANTENNA, TSA-4100, DATA.
- 2.13 TSS-4100 34-43-00.
- 2.14 TRAFFIC SURVEILLANCE SYSTEM, TSS-4100, DATA.
- 3 Operation
- 4 Maintenance
- 4.1 INTRODUCTION.
- 4.2 MAINTENANCE SCHEDULE.
- 4.3 CONVERSION FROM TTR/TDR TO TSS SYSTEM.
- 4.4 DATA LOADING.
- 4.5 TSS-4100 MODE S ADDRESS PROGRAMMING TOOL.
- 4.6 LED INDICATORS.
- 4.7 TEST EQUIPMENT AND POWER REQUIREMENTS.
- 4.8 TESTING AND TROUBLESHOOTING.
- 4.8.1 Pre-installation Testing.
- 4.8.2 TCAS Self Test.
- 4.8.3 Equipment Setup.
- 4.8.4 Radio Altitude System Failure Tests.
- 4.8.5 Pressure Altitude System Failure Tests.
- 4.8.6 Range and Bearing Test.
- 4.8.7 TCAS RA Test.
- 4.8.8 Transponder Tests.
- 4.8.9 ADS-B Transmit Ground Test.
- 4.8.10 Transponder/TCAS Suppression Bus Issues.
- 4.9 INITIAL INSTALLATION CHECK OUT PROCEDURE.
- 4.10 RETURN TO SERVICE TEST PROCEDURE.
- 4.11 INSPECTION/CHECK.
- APPENDIX A Faults and Warnings
- APPENDIX B Maintenance Words
- APPENDIX C Buses and Other Interfaces
- APPENDIX D Equipment Characteristics
- APPENDIX E Interconnect Diagram
- BACK COVER
523-0809018
SAFETY SUMMARY
1. GENERAL SAFETY INSTRUCTIONS.
This manual describes physical and chemical processes which may cause injury or death to personnel or damage to equipment if
not properly followed. This safety s ummary includes general safety precautions and instruction that must be understood and applied
during operation and maintenance to make sure personnel safety and protection of equipment. Prior to performing any task, the
WARNING, CAUTIONS, and NOTES included in that task shall be reviewed and understood.
2. W
ARNING, CAUTIONS AND NOTES.
WARNINGS and CAUTIONS are u sed in this manual to highlight operating or maintenance procedures, practices, conditions or
statements which are considered essential to protection of personnel (WARNING) or equipment (CAUTION). WARNINGS and
CAUTIONS immediately precede the step or procedure to which they apply. WARNINGS and CAUTIONS consist of four parts:
heading (WARNINGS, CAUTIONS or Icon [HAZAR DOUS MATERIALS WARNING ]), a statement of the hazard, minimum
precautions, and possible result if disregarded. NOTES are used in this m anual to h ighlight operating o r maintenance procedures,
practices, conditions or statements which are not essential to protection of personnel or equipment. NOTES may precede or follow
the step or procedure, depending upon the information to be highlighted. The headings used and definitions are as follows.
Highlights an essential operating or maintenance procedure, practice, condition, or statement, etc. which if not
strictly observed, could result in injury to, or death of, personnel or long term health hazards.
Highlights a
n essential operating or maintenance procedure, practice, condition, or statement, etc. which if not
strictly observed, could result in damage to, or destruction of, equipment or loss of mission effectiveness.
NOTE
Highlights an essential operating or maintenance procedure, condition, or statement.
xiii/(xiv Blank)