User Manual
Table Of Contents
- TSS-4100 Integrated TCAS, Transponder, and ADS-B Traffic Surveillance System
- TITLE PAGE
- LIST OF EFFECTIVE PAGES
- TABLE OF CONTENTS
- LIST OF ILLUSTRATIONS
- LIST OF TABLES
- INTRODUCTION
- SAFETY SUMMARY
- 1 General Information
- 2 System Components
- 2.1 INTRODUCTION.
- 2.2 COMPONENT DESCRIPTIONS.
- 2.3 ANT-42 34-54-00.
- 2.4 L-BAND ANTENNA, ANT-42, DATA.
- 2.5 ECU-3000 34-54-00.
- 2.6 EXTERNAL CONTROL UNIT , ECU-3000, DATA.
- 2.7 TDR-94D 34-54-00.
- 2.8 MODE S TRANSPONDER, TDR-94D, DATA.
- 2.9 TRE-930 34-54-00.
- 2.10 ANTENNA, TRE-930, DATA.
- 2.11 TSA-4100 34-54-00.
- 2.12 ANTENNA, TSA-4100, DATA.
- 2.13 TSS-4100 34-43-00.
- 2.14 TRAFFIC SURVEILLANCE SYSTEM, TSS-4100, DATA.
- 3 Operation
- 4 Maintenance
- 4.1 INTRODUCTION.
- 4.2 MAINTENANCE SCHEDULE.
- 4.3 CONVERSION FROM TTR/TDR TO TSS SYSTEM.
- 4.4 DATA LOADING.
- 4.5 TSS-4100 MODE S ADDRESS PROGRAMMING TOOL.
- 4.6 LED INDICATORS.
- 4.7 TEST EQUIPMENT AND POWER REQUIREMENTS.
- 4.8 TESTING AND TROUBLESHOOTING.
- 4.8.1 Pre-installation Testing.
- 4.8.2 TCAS Self Test.
- 4.8.3 Equipment Setup.
- 4.8.4 Radio Altitude System Failure Tests.
- 4.8.5 Pressure Altitude System Failure Tests.
- 4.8.6 Range and Bearing Test.
- 4.8.7 TCAS RA Test.
- 4.8.8 Transponder Tests.
- 4.8.9 ADS-B Transmit Ground Test.
- 4.8.10 Transponder/TCAS Suppression Bus Issues.
- 4.9 INITIAL INSTALLATION CHECK OUT PROCEDURE.
- 4.10 RETURN TO SERVICE TEST PROCEDURE.
- 4.11 INSPECTION/CHECK.
- APPENDIX A Faults and Warnings
- APPENDIX B Maintenance Words
- APPENDIX C Buses and Other Interfaces
- APPENDIX D Equipment Characteristics
- APPENDIX E Interconnect Diagram
- BACK COVER
system components 523-0809018
• Programmed by the installer
• Contains the Mode S address
• Either data l oaded, or p rogrammed using the TSS-4100 ECU Mode S Address Programming Tool.
Table 2-2. ECU Installation Strapping Data.
Description Values Recommend (Function Using Setting)
Installation Part Number Up to 16 alpha-numeric characters
Aircraft Instal lation 0000 0000 = Default
0000 0001 = BRS
Recommend: 0000 0001 (BRS)
Antenna Monitoring 1 = Enable Antenna Monitoring
0 = Disable Antenna Monitoring
Recommend: 1 (Enable)
Antenna Coaxial Cable Loss Upper 00 = Not use d
01 = 0 t o 1 db
10 = 1 t o 2 db
11 = 2 to 3 db
Antenna Coaxial Cable Loss Lower 00 = Not used
01 = 0 t o 1 db
10 = 1 t o 2 db
11 = 2 to 3 db
Antenna Coaxial C able Delay 00 = 0 to 50 nsec
01 = 51 to 150 nsec
10 =151 to 250 nsec
11 = 251 to 300 nsec
Cable Delay Sign Bit 1 = Add Cable Delay to Bottom Antenna
0=AddCableDelaytoTopAntenna
Share Antennas 1 = Enable (share antennas)
0 = Disable (independent antennas)
Recommend: 0 (Disable)
Bearing Lookup Configuration 0 = Standard
1 = Enhanced
Recommend: 1 (Enhanced)
Fan Speed 0 = 0 (Fan monitor n ot connected)
1..255 = 500..127500 (X times 500)
(In Pulses Per Minute)
Recommend: 42 (21000 pulses per
minute) if have TSM; 0 otherwise
RA Valid Disc rete Disable 1 = Disable RA Display Status Discrete
Monitor
0 = Enable RA Display Status Discrete
Monitor
Recommend: 0 (Enable) (TCAS)
Display All Traffic/Threat Traffic 1 = Display all intruders
0 = Display only TA and RA intruders
Recommend: 1 (Display all) (TCAS)
Ground Display Mode 1 = TCAS in Standby mode on ground
0 = TCAS in to TA Only mode on ground
Recommend: 0 (TA Only mode) (TCAS)
TA D isplay Intruder Limit Range 0 - 31 decimal Recommend: 31 (TCAS)
Default Altitude Limit A Range 0 - 127 decimal Recommend: 27 (2,700 ft) (TCAS)
2-10