User Manual
Table Of Contents
- TSS-4100 Integrated TCAS, Transponder, and ADS-B Traffic Surveillance System
- TITLE PAGE
- LIST OF EFFECTIVE PAGES
- TABLE OF CONTENTS
- LIST OF ILLUSTRATIONS
- LIST OF TABLES
- INTRODUCTION
- SAFETY SUMMARY
- 1 General Information
- 2 System Components
- 2.1 INTRODUCTION.
- 2.2 COMPONENT DESCRIPTIONS.
- 2.3 ANT-42 34-54-00.
- 2.4 L-BAND ANTENNA, ANT-42, DATA.
- 2.5 ECU-3000 34-54-00.
- 2.6 EXTERNAL CONTROL UNIT , ECU-3000, DATA.
- 2.7 TDR-94D 34-54-00.
- 2.8 MODE S TRANSPONDER, TDR-94D, DATA.
- 2.9 TRE-930 34-54-00.
- 2.10 ANTENNA, TRE-930, DATA.
- 2.11 TSA-4100 34-54-00.
- 2.12 ANTENNA, TSA-4100, DATA.
- 2.13 TSS-4100 34-43-00.
- 2.14 TRAFFIC SURVEILLANCE SYSTEM, TSS-4100, DATA.
- 3 Operation
- 4 Maintenance
- 4.1 INTRODUCTION.
- 4.2 MAINTENANCE SCHEDULE.
- 4.3 CONVERSION FROM TTR/TDR TO TSS SYSTEM.
- 4.4 DATA LOADING.
- 4.5 TSS-4100 MODE S ADDRESS PROGRAMMING TOOL.
- 4.6 LED INDICATORS.
- 4.7 TEST EQUIPMENT AND POWER REQUIREMENTS.
- 4.8 TESTING AND TROUBLESHOOTING.
- 4.8.1 Pre-installation Testing.
- 4.8.2 TCAS Self Test.
- 4.8.3 Equipment Setup.
- 4.8.4 Radio Altitude System Failure Tests.
- 4.8.5 Pressure Altitude System Failure Tests.
- 4.8.6 Range and Bearing Test.
- 4.8.7 TCAS RA Test.
- 4.8.8 Transponder Tests.
- 4.8.9 ADS-B Transmit Ground Test.
- 4.8.10 Transponder/TCAS Suppression Bus Issues.
- 4.9 INITIAL INSTALLATION CHECK OUT PROCEDURE.
- 4.10 RETURN TO SERVICE TEST PROCEDURE.
- 4.11 INSPECTION/CHECK.
- APPENDIX A Faults and Warnings
- APPENDIX B Maintenance Words
- APPENDIX C Buses and Other Interfaces
- APPENDIX D Equipment Characteristics
- APPENDIX E Interconnect Diagram
- BACK COVER
system components 523-0809018
Table 2-10. TSS-4100 Mating Connector Pins and Functions, ARINC 429 Output. - Continued
Pin Name Connector Pin A Pin B
CMU (Provision) RMP 9E 9F
General Purpose #1
(Provision)
LMP 9D 9C
Table 2-11. TSS-4100 Mating Connector Pins and Functions, GPS Time Mark Input.
Pin Name Connector Pin + Pin -
GPSTimeMark#1(On-side) LMP 9J 9K
GPS Time Mark #2
(Cross-side)
RMP 9J 9K
Table 2-12. TSS-4100 Mating Connector Pins and Functions, Discrete Input (Gnd = Active).
Pin Name Conn Pin Pin Name Conn Pin
Spare LMP 2H Advisory
Inhibit #3
LMP 11J
XTDR Active
(from XTDR)
LMP 2J Advisory
Inhibit #4
LMP 11K
Extended
Squitter Disable
LMP 2K Advisory
Inhibit #1
LMP 10J
Perf Limit LMP 3E Advisory
Inhibit #2
LMP 10K
Simulator
Enable
LMP 3F Shop Mode
Enable
RMP 6A
Air/Gnd(F) #1 LMP 3G ATE Discrete In
(Spare)
RMP 6B
Spare LMP 3H TA Display
Val i d #1
RMP 10A
Spare LMP 3J TA Display
Val i d #2
RMP 10B
Fan Monitor LMP 3K RA Display
Val i d #1
RMP 10C
Spare LMP 4F RA Display
Val i d #2
RMP 10D
Air/Gnd(F) #2 LMP 4H Burst Tune
Select
RMP 10E
Spare LMP 4J Control Port
Select 0
RMP 10F
2-62