User Manual
Table Of Contents
- TSS-4100 Integrated TCAS, Transponder, and ADS-B Traffic Surveillance System
- TITLE PAGE
- LIST OF EFFECTIVE PAGES
- TABLE OF CONTENTS
- LIST OF ILLUSTRATIONS
- LIST OF TABLES
- INTRODUCTION
- SAFETY SUMMARY
- 1 General Information
- 2 System Components
- 2.1 INTRODUCTION.
- 2.2 COMPONENT DESCRIPTIONS.
- 2.3 ANT-42 34-54-00.
- 2.4 L-BAND ANTENNA, ANT-42, DATA.
- 2.5 ECU-3000 34-54-00.
- 2.6 EXTERNAL CONTROL UNIT , ECU-3000, DATA.
- 2.7 TDR-94D 34-54-00.
- 2.8 MODE S TRANSPONDER, TDR-94D, DATA.
- 2.9 TRE-930 34-54-00.
- 2.10 ANTENNA, TRE-930, DATA.
- 2.11 TSA-4100 34-54-00.
- 2.12 ANTENNA, TSA-4100, DATA.
- 2.13 TSS-4100 34-43-00.
- 2.14 TRAFFIC SURVEILLANCE SYSTEM, TSS-4100, DATA.
- 3 Operation
- 4 Maintenance
- 4.1 INTRODUCTION.
- 4.2 MAINTENANCE SCHEDULE.
- 4.3 CONVERSION FROM TTR/TDR TO TSS SYSTEM.
- 4.4 DATA LOADING.
- 4.5 TSS-4100 MODE S ADDRESS PROGRAMMING TOOL.
- 4.6 LED INDICATORS.
- 4.7 TEST EQUIPMENT AND POWER REQUIREMENTS.
- 4.8 TESTING AND TROUBLESHOOTING.
- 4.8.1 Pre-installation Testing.
- 4.8.2 TCAS Self Test.
- 4.8.3 Equipment Setup.
- 4.8.4 Radio Altitude System Failure Tests.
- 4.8.5 Pressure Altitude System Failure Tests.
- 4.8.6 Range and Bearing Test.
- 4.8.7 TCAS RA Test.
- 4.8.8 Transponder Tests.
- 4.8.9 ADS-B Transmit Ground Test.
- 4.8.10 Transponder/TCAS Suppression Bus Issues.
- 4.9 INITIAL INSTALLATION CHECK OUT PROCEDURE.
- 4.10 RETURN TO SERVICE TEST PROCEDURE.
- 4.11 INSPECTION/CHECK.
- APPENDIX A Faults and Warnings
- APPENDIX B Maintenance Words
- APPENDIX C Buses and Other Interfaces
- APPENDIX D Equipment Characteristics
- APPENDIX E Interconnect Diagram
- BACK COVER
system components 523-0 809018
Table 2-12. TSS-4100 Mating Connector Pins and Functions, Discrete Input (Gnd = Active). - Continued
Pin Name Conn Pin Pin Name Conn Pin
Climb Inhibit
#1
LMP 11A Control Port
Select 1
RMP 10G
Climb Inhibit
#2
LMP 11B Advisory
Annun Cancel
RMP 10H
Climb Inhibit
#3
LMP 11C Spare RMP 10J
Climb Inhibit
#4
LMP 11D Data Load
Enable
RMP 10K
Increase Climb
Inh #1
LMP 11E Program Pin
Common
RMP 11H
Increase Climb
Inh #2
LMP 11F Source
Destination
Identifier (SDI)
Position 1
RMP 11J
Increase Climb
Inh #3
LMP 11G SDI Position 2 RMP 11K
Increase Climb
Inh #4
LMP 11H
Ctrl Port:
Ctrl
Port
Sel 0
Ctrl
Port
Sel 1 SDI code:
SDI
Pos 1
SDI
Pos 2
Gnd Open Ctrl Bus A Gnd Open Side 1 - Left
Open Open Ctrl Bus B Open Gnd Side 2 - Right
X Gnd Ctrl Bus C Open Open Not Used
Gnd Gnd Not Used
Table 2-13. TSS-4100 Mating Connector Pins and Functions, Discrete Output (Gnd = Active).
Pin Name Conn Pin Pin Name Conn Pin
TSS Active (to
XTDR)
LMP 2E Test Data 1 RMP 6D
Spare +28/Open LMP 2F Test Data 2 RMP 6E
Spare LMP 2G Test Data 3 RMP 6F
Visual Annun C LMP 3A Test Data 4 RMP 6G
Visual Annun P LMP 3B Test Data 5 RMP 6H
Visual Annun
TA
LMP 3C Test Data 6 RMP 6J
Fan Off
(100ma)
LMP 3D Test Data 7 RMP 6K
2-63