Switch User Manual
Table Of Contents
- 1783-UM002C-EN-E, Stratix 8000 Ethernet Managed Switches Hardware User Manual
- Preface
- Table of Contents
- 1 - Start
- 2 - Install the Switch
- Installation Guidelines
- Before You Begin
- Verify Package Contents
- Add Modules to the Switch
- Install the Switch
- Install or Remove the CompactFlash Card
- Set Up the Switch Initially with Express Setup
- Configure and Manage the Switch
- Reset the Switch to Factory Defaults
- Connect to the Switch Ports
- Verify Port Connectivity
- Verify Switch Operation
- Connect a Computer or a Terminal to the Console Port
- Run a Power-on Self-test (POST)
- Verify POST Results
- Disconnect Power
- Install and Remove SFP Modules
- Connect to SFP Modules
- 3 - Troubleshoot the Switch
- 4 - Cable and Connectors
- Index
- Back Cover
Publication 1783-UM002C-EN-P - April 2009 37
Chapter 2
Install the SFP Module (optional)
Grasp the module on the sides, and insert it into the switch slot until you feel
the connector snap into place.
ATTENTION
SFP modules are static sensitive devices. Always use an ESD
wrist strap or similar individual grounding device when
handling SFP modules.
IMPORTANT
Using an SFP module other than those provided by Rockwell
Automation will disable the switch port.
IMPORTANT
Installing and removing an SFP module can shorten its useful
life. Do not remove and insert SFP modules more often than is
absolutely necessary.
ATTENTION
If the SFP module cannot be fully inserted, stop! Do not force the module into
the slot. Rotate the SFP module 180 degrees and try again.
31782-M