Technical Specifications

MINI CIRCULAR SAW WITH LASER ENG
14
WORKING HINTS FOR YOUR
TOOL
If your Versacut becomes too hot, please run your
Versacut
TM
no load for 2-3 minutes to cool the motor.
Avoid prolonged usage under strenuous cutting loads.
Protect saw blades against impact and shock. Excessive
feed significantly reduces the performance capability
of the machine and reduces the service life of the saw
blade. Sawing performance and cutting quality depend
essentially on the condition and the tooth count of the
saw blade. Therefore, use only sharp saw blades that are
suited for the material to be worked.
Choice of blades: 24 teeth for general work, approx. 40
teeth for finer cuts, more than 40 teeth for very fine cuts
into delicate surfaces, diamond for tile, cement board,
etc.
MAINTAIN TOOLS WITH CARE
Remove the plug from the socket before carrying
out any adjustment, servicing or maintenance.
Keep tools sharp and clean for better and safer
performance. Follow instructions for lubricating and
changing accessories. Inspect tool cords periodically
and if damaged, have repaired by authorized service
facility. Your power tool requires no additional lubrication
or maintenance. There are no user serviceable parts in
your power tool. Never use water or chemical cleaners
to clean your power tool. Wipe clean with a dry cloth.
Always store your power tool in a dry place. Keep the
motor ventilation slots clean. Keep all working controls
free of dust.
If the supply cord is damaged, it must be replaced by
the manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard.
Periodically clear dust and chips from guard and base to
ensure proper performance.
TROUBLESHOOTING
Symptom Possible Causes Possible Solution
Tool will not start when
operating the on/off switch.
Power cord not plugged in.
Power cord is broken.
Carbon brush has worn down.
Check to make sure power cord is connected
well into a working outlet.
Unplug the power cord. Replace it using a
qualified maintenance person.
Replace the carbon brush using a qualified
maintenance person.
Cutting depth is less than
that is set.
Sawdust accumulated at the rear
of the base.
Shake out sawdust. Consider connecting a
vacuum for dust collection.
Blade spins or slips
Blade is not tightly engaged with
the spindle.
Remove the blade, and reassemble it as
described in INSTALL /CHANGE THE BLADE
section.
Blade will not cut a straight
line.
Blade is dull.
Blade is not mounted properly.
Saw is not being guided properly.
Mount a new, sharp blade on the saw.
Check that blade is properly mounted.
Use and edge guide.
Blade kicks back when
beginning a cut.
Blade is not spinning fast enough.
Allow the saw blade to reach full speed prior to
beginning a cut.