Operating instructions
10
SoniCrafter
TM
ENG
premature wear.
If one point has become worn, pull off the sanding
sheet, turn it 120° and replace.
3. MOUNTING THE SUCTION DEVICED)
WARNING:
power plug.
This preventative safety measure eliminates danger
from accidentally starting the power tool. Mount the
suction device as shown in C1-D2.(RK5102K)
4. OPERATING THE ON/OFF SWITCH
- Switching the power tool ON:
Slide switch (17) forward (I).
- Switching the power tool OFF:
Slide switch (17) backward (0).
5. USING THE VARIABLE SPEED CONTROL
Select oscillation frequency (speed) while the motor is
running.
The variable speed control (18) can be used to set
the optimum oscillating frequency according to the
accessories used and the respective application.
High oscillation frequency:
Sanding, sawing, rasping and polishing stone and
metal.
Low oscillation frequency:
Polishing varnishes.
6. SECURING THE WORKPIECE
CAUTION: Before working with your tool make
sure that no power cords will be damaged.
Typical application: wood, metal; small areas, especially
corners, edges and places difcult to access.
Select high oscillation frequency (for variable speed
models).
Sand with a constant movement and light pressure.
Heavy pressure does not increase the removal – the
sanding sheet merely wears faster.
Typical application: wood, plastics, sheet metal.
Select high oscillation frequency (for variable speed
models).
The saw blade lasts longer if the wear is distributed
evenly. To ensure an even distribution, loosen the saw
blade, rotate it and retighten rmly.
WARNING: T
The workpiece must be inserted rmly or clamped
tightly before it is cut.
Typical application: wood, plaster board, soft plastics
and metal (e. g. nails).
When plunging and sawing use a slight pendulum
motion, to allow sufcient chip removal.
10. Scraping
Typical application: Scraping off old varnish or
adhesives, removing glued carpeting, e. g. on stairs or
other small to medium-sized surfaces.
Select medium / high oscillation frequency (for variable
speed models).
WORKING HINTS FOR YOUR TOOL
If your power tool becomes too hot, especially when
used at low speed, set the speed to maximum and run
it with no load for 2-3 minutes to cool the motor. Avoid
prolonged usage at very low speeds. Always keep the
blade sharp.
Always ensure the workpiece is rmly held or clamped
to prevent movement.
Any movement of the material may affect the quality of
the cutting or sanding nish.
Start your tool before working and turn it off only after
you stop working.
Do not start sanding without having the sandpaper
tted.
Do not allow the sandpaper to wear away , it will damage
the sanding pad. The guarantee does not cover sanding
pad wear and tear.
Use coarse grit paper to sand rough surfaces, medium
grit for smooth surfaces and ne grit for the nishing
surfaces. If necessary, rst make a test run on scrap
material.
Excessive force will reduce the working efciency
and cause motor overload. Replacing the accessory
regularly will maintain optimum working efciency.
MAINTAIN TOOLS WITH CARE