Operating instructions
9
SoniCrafter
TM
ENG
SYMBOLS TECHNICAL DATA
Model RK5100K RK5101K RK5102K
Rated voltage 120 V~60 Hz
Rated current 2.3 A
Oscillations
speed
20000 /min 11000-20000 /min
Oscillations
angle
3.2 °
Protection
class
/II
Weight 2.8 Lbs
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the instruction
book carefully.
1. MOUNTING ACCESSORIES (See A1 A2)
CAUTION: For all work or when changing
application tools, always wear protective gloves.
Avoid danger of injury from the sharp edges of the
application tools. Application tools can become very
hot while working, presenting danger of burns!
WARNING: To reduce the risk of injury, do not let
the Universal end cut blades or any segment saw
blades face back toward the user’s hand.
Unscrew the bolt (8) and remove the ange (9).
Clean the tool holder, the application tool and the bolt
(8) and ange (9).
Place the application tool exactly onto the hex-shaped
tool holder. Note that the application tool has a ush t.
Reposition the ange and tighten the bolt (8) using the
supplied Allen key.
2. MOUNTING / CHANGING THE SANDING SHEET (See
Align the sanding sheet and press it onto the sanding
pad by hand.
Align the holes of the perforated sanding sheets with
the holes of the perforated sanding pads when used.
(see B2)
Firmly press the power tool with the sanding sheet
against a at surface and briey switch the power tool
on. This provides for good adhesion and prevents
To reduce the risk of injury, user must read
instruction manual
Warning
Wear ear protection
Wear eye protection
Wear dust mask
Double insulation