Use and Care Manual

10
10˝ DRILL PRESS ENG
SYMBOLS
Read the manual
Warning
Wear ear protection
Wear eye protection
Wear dust mask
n
o
No-load speed
TECHNICAL DATA
Voltage 120 V-60 Hz
Amps 6.2 A
Rated speed 620-3100/min
Swing 10˝
Spindle travel 2˝
Table size 8˝ x 6-1/2˝
Throat depth 4-15/16˝
Table bevel range 0-45
o
Left & Right
Speed settings 5
Weight 48.3 lbs
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the instruction
book carefully.
WARNING: To prevent personal injury, do not
connect the machine to the power source until
the machine is completely assembled and you have read
and understand the entire instruction manual. Always
disconnect the plug from the power source before
assembling parts, making adjustments or changing drill
bits.
ASSEMBLY
1. ASSEMBLY OF MACHINE BASE/COLUMN
1) Position Machine Base on floor (See Fig.A)
Remove protective sleeve from Column tube and
discard. Place Column assembly onto Machine Base,
and align holes in Column support with holes in Base.
Install a bolt in each hole (through Column support
and Base) and tighten the Fixing Bolts (8) with
adjustable wrench.
2) Locate the elevation worm gear (a) (in loose parts
bag) and the Table Crank. Insert the shaft of the
elevation worm gear into the table support bracket
(b) and extend the shaft through the opening as far
as possible. Attach the Table Crank to the shaft with
the set-screw (c). The set-screw is to be aligned with
the flat portion of the shaft. The Table Crank is to be
positioned as close to the arm support as possible,
then tighten the set-screw with the Allen Key provided.
Do not over-tighten the set-screw. (See Fig. B)
3) Remove Collar from the Column. With the long
smooth end of the raising rack (d) pointing upward,
slide the raising rack down the Column until the
bottom of the rack is aligned inside the flange on the
base of the Column. (See Fig. C). While holding the