Use and Care Manual

7
PORTABLE WORK SUPPORT ENG
COMPONENT LIST
LOW FRICTION SKIDS
CLAMP KNOB
BEVEL HEAD
BEVEL LOCKING KNOB
COLUMN
BASE
LEG
NON SKID RUBBER FEET
HEIGHT LOCKING KNOB
BEVEL SCALE
POINTER
LEVELING BUBBLE
MOVING CLAMP PAD
FIXED CLAMP PADS
1
8
2
9
3
10
4
11
5
12
6
13
SAFETY INSTRUCTIONS
WARNING: When using this product basic safety
precautions should always be followed. Failure
to follow all instructions listed below may result in
personal injury.
Read all these instructions before attempting to operate
this product and save these instructions.
1. Keep work area clear.
- Cluttered areas and benches invite injuries.
2. Make sure all moving parts are free from
interference.
3. Ensure JAWSTAND
TM
is set up on firm, level
ground in a stable manner.
4. Keep other persons away.
- Do not let persons, especially children, not involved in
the work touch the tool and keep them away from the
work area.
5. Be aware of over-balancing. When a large piece
is cut from one end of a job, the remaining piece may be
heavy enough to tip the JAWSTAND
TM
. Always ensure
the workpiece is well supported.
6. Check to make sure that all fixing screws
and knobs are tight and all legs are correctly
positioned.
7. The tool must be used only for its prescribed
purpose. Any use other than those mentioned in these
instructions will be considered a case of misuse.
The manufacturer shall not be liable for any damage or
injury resulting from such cases of misuse.
8. Never stand on this product.
9. Dress properly.
- Do not wear loose clothing or jewelry, they can be
7
14