SCRAMBLER IS DE-ACTIVATED RMR-C495 Radar and Laser Detector Radar and Laser Scrambler Owners Manual
SPECIFICATIONS: Radar & Laser Detector: Frequencies: 24.125 GHz 33-36 GHz 904 Nano-meter Sensitivity: K-110Dbm Ka-wide-102 Dbm Laser < 200 nano-watt Alarm: Separate for each Band Variable alarm for Range Controls: Volume, On/Off, Voice, Language, Tone, Dim, Mute, City/Highway, Test, Scrambler, All Reset Spectre: 100% Undetectable [Spectre I, II, VG-2: III; VG-2,3] Size: 1.4” x 3.0” x 4.4” Other: 1-Year Ticket Rebate Program and a 3Year Warranty.
Mounting the RMR-C495 to your windshield: 1) Attach the windshield bracket to the RMR-C495 unit. Align the edge on the bracket with the slot opening on the front of the case. Slide the bracket gently into the case until it locks into place. Make sure not to twist the bracket while inserting. 2) Place the windshield bracket in the upper center portion of the windshield. The ideal position will be right below the rearview mirror. Press suction cups firmly against windshield to adhere suction cups.
CONTROLS: There are 3 buttons on top of the RMR-C495: Dim/Menu, Mute/Select and City. Dim: To adjust brightness press the Dim button for a split second (momentary contact) to select between Bright, Dim, Dimmer, and Dark. To brighten the alarm lights press the Dim Button again until you reach desired setting. In Dark mode there will be a “P” light on. If a signal is present there will be no visual band alert only a sound alert. Note: If the unit is in Dark mode the Mute mode cannot be engaged.
Reminder! The C495 will memorize the settings of the features above when the unit is powered off. Be sure to re-adjust the settings to your normal preferences. Tutorial Mode: To run the system diagnostics check on the unit press and hold down both the Mute and City buttons simultaneously for an extended period of time (approximately 3 to 5 seconds). The unit will perform a test sequence to verify all systems are operating properly.
On the C495 the new MMIC prevents detection of the radar detector completely. Diagnostics: The RMR-C495 has a full internal automatic diagnostic system. If the power light goes off and remains off, check the 2-amp fuse in the power cord by unscrewing the silver tip and removing the fuse. If the fuse is good (wire inside the fuse unbroken), return the unit for service.
SPECIFICATIONS: Radar Scrambler: Frequencies: 8.0-38.2 GHz Antenna: Dual ridge cast waveguide Mixer: Custom MM wave Schottky Doppler: Pseudo Random Digital Noise Generator Lidar Scrambler: Full laser coverage using asynchronous pulse position modulation to confuse the lidar computer. How does it work? The Rocky Mountain Radar scramblers are fullfeatured radar and laser scramblers combining active laser and passive radar scrambling capabilities.
SCRAMBLER ACTIVATION: the scrambler. During the start up sequence the current menu settings are displayed. All scramblers are factory set to the OFF position. Please read instructions before activating the scrambler. Scrambler: RMR-C495 to turn the scrambler on/off. RMR-C495 1. Press and hold the Menu button until “MENU” is displayed. 2. Press the Menu button in increments until SCRM is displayed. (While in the Menu mode if no button is pressed the Menu will exit in 5 seconds.) 3.
IS IT LEGAL? The Rocky Mountain Radar scramblers conform to all FCC rules and regulations. Part 15 of the FCC code regulates consumer products that may leak or transmit radio frequency energy into the atmosphere. Since the scramblers are not transmitters, these sections do not apply. The radar scrambler is a reflective receiver and has no emissions. It does not transmit, but uses the police radar gun’s own signal as a carrier of its information. The laser scrambler transmits a series of light pulses.
(unless the switchable scrambler feature is set to off) and Virginia. The Rocky Mountain Radar detectors are not legal in commercial vehicles in most states. Use caution in these states. • What is Punch-Through? The signal reflected by the car gets stronger the closer the target is to the radar gun. The Rocky Mountain Radar scrambler uses the radar signal as a carrier and reflects it through a high-gain antenna. It will work only as long as the scrambling signal is greater than the signal from the target.
Warranty The RMR-C495 is guaranteed against defects in workmanship and materials for 36 months from the date of purchase. Should any malfunction occur, the unit will be repaired or replaced by the factory at no additional cost. Returns should be sent freight prepaid with an explanation of the problem, your physical address (no PO Boxes), proof of purchase, and telephone number. If the unit is out of warranty there is a $62.00 service fee and a 90 day warranty on repairs.
Follow us on Manufactured Exclusively by Rocky Mountain Radar in the USA www.rockymountainradar.
