Instruction Manual

5) Clean thoroughly the surface area where the RMR-
RS202 will be placed using rubbing alcohol.
6) Peel off remaining side of double sided tape and apply
RMR-RS202 to vehicle. Make sure the cable connector is
facing down.
7) Do not drill any holes on RMR-RS202.
8) Keep front lens clean and free of debris.
Connecting your RMR-RS202
For installation with an RMR-8RD
1) Route RMR-RS202 cable through vehicle keeping
away from moving parts and hot surfaces. (Radiator hoses,
engine, etc) and pass through the fire wall under the dash.
2) Connect RMR-RS202 plug into AUX jack on the
RMR-8RD control module.
For installation without an RMR-8RD
1) Remove plug from the end of the cable.
2) Strip the 2 wires.
3) Locate a switched +12V source in your vehicle.
4) Connect red wire to +12V, white wire to Ground.
The green power light will illuminate on the RMR-
RS202 when it is powered on.
WARRANTY