Manual

NAS System
User’s Manual
13
2.4 Getting Started with the NAS System
2.4.1 NAS Hardware Setup
1. Attach network cable to LAN0 Ethernet port. Connect the other end of network cable
to your network hub or switch. You may also connect the other Ethernet ports if
needed.
2. Plug in the power cord into the AC Power Input Socket located at the rear of the
subsystem.
3. To turn on the NAS, press the Power On/Off Switch of power supply at the rear. Then
turn on the main switch button in the front panel.
4. The Power LED on the front panel will turn green.
2.4.2 Installing Hard Drives
2.4.2.1 Installing 3.5” Disk in a Disk Tray
This section describes the location of the hard drives in the NAS system and gives
instructions on installing a hard drive. The system supports hot-swapping allowing you
to install or replace a hard drive while the system is running.
a. Make sure the lock indicator is in unlocked position. To pull out a disk tray, press
the Lock Indicator Button. Pull the handle outwards to remove the disk tray from
the enclosure.
Drive Tray is Unlocked