Installation Guide

Installation Instruction for Ceiling Mount Track
MOUNTING THE TRACK:
Screw the track directly to the ceiling, placing one screw through each of the pre-drilled holes across the length
of the track. Be sure that there is a screw within 6 inches of each end of the track. Additional holes may need to
be drilled in the flange of the track to complete your particular installation.
MOUNTING THE DRAPE:
1. Start hanging the drape at the Master Carrier: The first pin-hook goes into the end hole of the arm of the
master carrier the second will be hooked into the second hole of the master carrier arm.
2. Each pin will be hooked into a separate slider until you reach the end of the drape or the end cap of the
track.
3. Remove any excess sliders if needed by removing the end cap and sliding them out of the track.
4. Replace the end cap and do not over-tighten the screw, just snug the screw in place. Over-tightening
may damage the end cap.
MOUNTING THE BATONS:
Attach the baton to the last hole of the master carrier along with the pin of the drapery OR clip the baton’s metal
snap to the bottom loop of the master carrier. The baton will be hidden behind the drape when using this last
baton installation technique
TECHNICAL SUPPORT: 1-866-326-1989