USER GUIDE
OVERVIEW The Wireless Go is a compact wireless microphone system that operates in the 2.4GHz spectrum. The kit includes a transmitter with an internal microphone and a reciever with 3.5mm TRS output. SET UP Press and hold the power button for 3 seconds to turn on the the RX (receiver). Press and hold the power button for 3 seconds to turn on the TX (transmitter). The units will already be paired and start transmitting audio, the transmitter will be using the internal microphone.
TRANSMITTER – TX Power Button Press and hold the power button for 3 seconds to turn on the unit Press and hold the power button for 3 seconds to turn off the unit Single press to turn on when the device is in charging mode Internal Microphone The transmitter will use the internal microphone if there is not an external microphone plugged in On board processing optimised for the human voice Audio Output Standard 3.5mm TRS microphone input Supplies 2.
RECEIVER – RX Power Button Power Button Press and hold the power button for 3 seconds to turn on the unit Press and hold the power button for 3 seconds to turn off the unit Single press to turn on when the device is in charging mode Single press when the device is switched on to change screen brightness mode.
SPECIFICATIONS Transmission type: Internal Capsule Acoustic Principle: Polar Pattern: Equivalent Input Noise @ Maximum Gain: Frequency Range: 2.4GHz Frequency Agile Digital System Pre-polarised pressure transducer Omnidirectional 21.