Instruction manual

- 13 -
FITTING YOUR HS1
- 13 -
ADJUST THE LENGTH OF THE HS1
If the HS1 is extending beyond your mouth, or is not in close
enough proximity to it, you may alter the length by pushing or
pulling the body through the retainer.
Firstly, ensure the retainer cap has been loosened, but not removed
completely. Hold the mic body at the connector end and twist
90° (1/4 turn) to unlock it from the retainer clasp. The push/pull
motion is controlled by friction so apply a little force if required. If
necessary, twist the microphone body back and forth while pushing/
pulling to encourage the mic body through the retainer and create
the desired length. When adjustment has been completed, tighten
the retainer cap securely into place.
Push or pull the body of the HS1 through the retainer clasp using a twisting motion
117-950-3-1-HS1_manual.indd 13117-950-3-1-HS1_manual.indd 13 28/11/2012 3:48:11 PM28/11/2012 3:48:11 PM