Manualshelf

User manual

ManualsBrandsROHDE & SCHWARZ ManualsLaboratory Test EquipmentHandheld (scope-meter) RTH1002 60 MHz 500 null 10 Bit
171172173174175176177178179180
General Instrument Setup
R&S
®
Scope Rider RTH
143User Manual 1326.1578.02 ─ 04
10 General Instrument Setup
The general instrument settings are available in all operating modes.
Reset
To switch off the instrument and reset the hardware, press the
power key for 5 sec-
onds. This is helpful if the instrument is in undefined condition and cannot be operated.
To restore the factory settings, hold down the PRESET key during the boot process.
Environment with high immissions
If you use the instrument in an environment with immissions considerably higher than
specified, the immisions may affect the touch sensitivity of the screen. In this case, dis-
able the touch and operate the instrument using the keys and the wheel.
Use "Display" > "Enable Touch" to disable the touch.
10.1 Instrument Settings
Access: or "Setup" menu
Selfalignment
See Chapter 10.2, "Selfalignment", on page 144.
Instrument Settings