User manual

Remote Control Commands
R&S
®
Scope Rider RTH
188User Manual 1326.1578.02 ─ 04
Parameters:
<Scale> Range: 1E-12 to 500
Increment: 1E-12
*RST: 100E-9
Default unit: s
ZOOM:POSition <Position>
Sets the center position of the zoomed area in relation to the trigger point.
Parameters:
<Position> Range: -500 to 500
Increment: 1E-12
*RST: 0
Default unit: s
12.4.2 Automatic Measurements
In remote commands for automatic measurements, the suffix <m> defines the mea-
surement index. You can perform up to four different measurements simultaneously.
● Measurement Settings.......................................................................................... 188
● Measurement Results........................................................................................... 190
12.4.2.1 Measurement Settings
MEASurement<m>:ENABle............................................................................................ 188
MEASurement<m>:SOURce........................................................................................... 188
MEASurement<m>:TYPE............................................................................................... 189
MEASurement<m>:AOFF............................................................................................... 189
MEASurement<m>:DELay:SLOPe...................................................................................190
MEASurement<m>:ENABle <State>
Enables or disables the measurement.
Suffix:
<m>
.
1..4
Parameters:
<State> ON | OFF
*RST: OFF
MEASurement<m>:SOURce <Source>, [<Source2>]
Defines the waveform to be measured. For delay, phase, and power measurements, 2
sources are required.
Waveform Analysis