User manual

Remote Control Commands
R&S
®
Scope Rider RTH
197User Manual 1326.1578.02 ─ 04
REFCurve:POSition <Position>
Sets the vertical position of the reference waveform.
Parameters:
<Position> Default unit: DIV
REFCurve:NAME <Name>
Defines the path, file name and file format of the reference waveform file.
The default path is C:/Users/<user>/Rohde-Schwarz/RTH/ReferenceCurves.
Parameters:
<Name> String
Example:
:REFCurve:NAME 'C:
/Users/user1/Rohde-Schwarz/RTH/ReferenceCurves/reference001.csv'
REFCurve:SAVE
Saves the reference waveform. The target file is specified using REFCurve:NAME.
Usage:
Event
REFCurve:OPEN
Loads a stored reference waveform from the specified file. The file is specified using
REFCurve:NAME.
Usage:
Event
REFCurve:DELete
Deletes a stored reference waveform file. The file is specified using REFCurve:NAME.
Usage:
Event
12.4.6 History (Option R&S RTH-K15)
In CHANnell:HISTory commands, the channel suffix is irrelevant, omit it.
See also: Chapter 3.7, "History (Option R&S RTH-K15)", on page 90
CHANnel<m>:HISTory[:STATe].......................................................................................198
CHANnel<m>:HISTory:NSEGments.................................................................................198
CHANnel<m>:HISTory:TPACq........................................................................................ 198
ACQuire:AVAilable?....................................................................................................... 198
CHANnel<m>:HISTory:STARt......................................................................................... 198
CHANnel<m>:HISTory:STOP..........................................................................................199
CHANnel<m>:HISTory:CURRent.....................................................................................199
Waveform Analysis