User manual

Remote Control Commands
R&S
®
Scope Rider RTH
225User Manual 1326.1578.02 ─ 04
Parameters:
<Bitrate> BPS_300 | BPS_600 | BPS_1200 | BPS_2400 | BPS_4800 |
BPS_9600 | BPS_14400 | BPS_19200 | BPS_28800 |
BPS_38400 | BPS_56000 | BPS_57600 | BPS_115200 |
BPS_128000 | BPS_230400 | BPS_460800 | BPS_921600 |
CUSTom
Values in bits per second.
CUSTom: Set the bit rate using BUS:UART:BITRate.
*RST: BPS_14400
BUS:UART:BITRate <CustomBitrate>
Sets a user-defined bit rate if BUS:UART:STDBitrate is set to CUSTom.
Parameters:
<CustomBitrate> Range: 300 to 20000000
Increment: 1
*RST: 14400
BUS:UART:SSIZe <DataBits>
Sets the number of data bits in a word (symbol).
Parameters:
<DataBits> B5 | B6 | B7 | B8 | B9
*RST: B8
BUS:UART:PARity <Parity>
Defines the optional parity bit that is used for error detection.
Parameters:
<Parity> NONE | ODD | EVEN
NONE
No parity bit is used.
ODD
The parity bit is set to "1" if the number of data bits set to "1" is
even.
EVEN
The parity bit is set to "1" if the number of data bits set to "1" is
odd.
*RST: NONE
BUS:UART:SBIT <StopBits>
Sets the number of stop bits: 1 or 1.5 or 2 stop bits are possible.
Protocol Analysis