Instructions

Fernsteuerbefehle
R&S
®
Scope Rider RTH
332Bedienhandbuch 1326.1578.03 ─ 10
Parameter:
<Pattern> String that contains the pattern in binary format. The parameter
accepts the bit value X (don't care).
Beispiel:
TRIGger:SPATtern:PATTern '11001100'
TRIGger:SPATtern:PATTern '110011XX'
15.3.5.13 Timeout-Trigger (R&S RTH-K19)
TRIGger:TIMeout:RANGe...............................................................................................332
TRIGger:TIMeout:TIME.................................................................................................. 332
TRIGger:TIMeout:RANGe <TimeoutMode>
Selects the relation of the signal level to the trigger level, which is specified with
TRIGger:LEVel<m>:VALue
Parameter:
<TimeoutMode> HIGH | LOW | EITHer
*RST: HIGH
TRIGger:TIMeout:TIME <Time>
Sets the time limit for the timeout at which the instrument triggers.
Parameter:
<Time> Bereich: 100E-12 bis 10000
Inkrement: 100E-9
*RST: 5E-9
Std-einheit: s
15.3.5.14 Intervalltrigger (R&S RTH-K19)
TRIGger:INTerval:SLOPe............................................................................................... 332
TRIGger:INTerval:RANGe...............................................................................................333
TRIGger:INTerval:WIDTh................................................................................................333
TRIGger:INTerval:DELTa................................................................................................333
TRIGger:INTerval:MINWidth............................................................................................333
TRIGger:INTerval:MAXWidth.......................................................................................... 334
TRIGger:INTerval:SLOPe <Slope>
Sets the edge direction for the trigger. You can analyze the inteval between positive
edges or between negative edges.
Parameter:
<Slope> POSitive | NEGative
*RST: POSitive
Grundeinstellungen