Instructions

Fernsteuerbefehle
R&S
®
Scope Rider RTH
338Bedienhandbuch 1326.1578.03 ─ 10
Parameter:
<State> ON | OFF
*RST: OFF
MEASurement<m>:SOURce <Source>, [<Source2>]
Defines the waveform to be measured. For delay, phase, and power measurements, 2
sources are required.
The sources can be any active input signal, math or reference waveform. Available
source waveforms depend on the measurement type, see Kapitel 4.2.3, "Messtypen",
auf Seite 84.
Suffix:
<m>
.
1..4
Parameter:
<Source> C1 | C2 | C3 | C4 | M1 | R | D0 | D1 | D2 | D3 | D4 | D5 | D6 | D7
<Source2> C1 | C2 | C3 | C4 | M1 | R | D0 | D1 | D2 | D3 | D4 | D5 | D6 | D7
MEASurement<m>:TYPE <Type>
Selects the measurement type. For a detailed description, see Kapitel 4.2.3, "Messty-
pen", auf Seite 84.
Suffix:
<m>
.
1..4
Parameter:
<Type> PERiod | FREQuency | RTIMe | FTIMe | PPULse | NPULse |
PDCYcle | NDCYcle | DELay | PHASe | MEAN | RMS | CRESt |
STDDev | MINimum | MAXimum | PKPK | BASelevel |
TOPLevel | AMPLitude | OVRShoot | PREShoot | AC | DC |
ACDC | PPCount | NPCount | RECount | FECount | PWRP |
PWRS | PWRQ | PWRFactor
*RST: MINimum
RTIMe Rise time PREShoot Preshoot
FTIMe Fall time PPCount Positive pulse count
PPULse Positive pulse width NPCount Negative pulse count
NPULse Negative pulse width RECount Rising edge count
PDCYcle Positive duty cycle FECount Falling edge count
NDCYcle Negative duty cycle PWRP Active power
STDDev Standard deviation PWRS Apparent power
PKPK Peak to peak PWRQ Reactive power
OVRShoot Overshoot PWRFactor Power factor
Messkurvenanalyse