User manual

Remote Control Commands
R&S
®
Scope Rider RTH
160User Manual 1326.1578.02 ─ 04
12.3 Waveform Setup
● Automatic Setup....................................................................................................160
● Vertical Setup........................................................................................................160
● Horizontal Setup....................................................................................................164
● Acquisition Control................................................................................................ 166
● Trigger...................................................................................................................168
12.3.1 Automatic Setup
AUToscale
Performs an autoset in scope mode.
Usage:
Event
12.3.2 Vertical Setup
The channel suffix <m> selects the channel for which the command is executed. The
number of channels depends on the instrument type. The R&S RTH1004 has 4 chan-
nels, the suffix values are 1 | 2 | 3 | 4. The R&S RTH1002 has 2 channels, the suffix
values are 1 | 2.
Make sure to set the attenuation factor on the instrument according to the probe being
used. Otherwise, the measurement results do not reflect the actual voltage level, and
you might misjudge the actual risk.
CHANnel<m>:STATe..................................................................................................... 160
CHANnel<m>:SCALe..................................................................................................... 161
CHANnel<m>:RANGe.................................................................................................... 161
CHANnel<m>:PROBe.................................................................................................... 161
CHANnel<m>:POLarity...................................................................................................162
CHANnel<m>:POSition...................................................................................................162
CHANnel<m>:OFFSet.................................................................................................... 163
CHANnel<m>:COUPling.................................................................................................163
CHANnel<m>:BANDwidth...............................................................................................163
CHANnel<m>:DESKew.................................................................................................. 164
CHANnel<m>:STATe <State>
Switches the channel signal on or off.
Suffix:
<m>
.
1|2 (RTH1002) , 1..4 (RTH1004)
Parameters:
<State> ON | OFF
*RST: OFF
Waveform Setup