User manual

Remote Control Commands
R&S
®
Scope Rider RTH
179User Manual 1326.1578.02 ─ 04
Parameters:
<Tolerance> Range: 0 to 5000
Increment: 500E-12
*RST: 0
Default unit: s
12.3.5.8 Slew Rate Trigger
See also Chapter 2.5.9, "Slew Rate Trigger (R&S RTH-K19)", on page 62.
TRIGger:LEVel<m>:SLEW:LOWer...................................................................................179
TRIGger:LEVel<m>:SLEW:UPPer................................................................................... 179
TRIGger:SLEW:SLOPe.................................................................................................. 179
TRIGger:SLEW:RANGe..................................................................................................179
TRIGger:SLEW:RATE.................................................................................................... 180
TRIGger:SLEW:DELTa...................................................................................................180
TRIGger:LEVel<m>:SLEW:LOWer <Level>
TRIGger:LEVel<m>:SLEW:UPPer <Level>
Set the upper and lower voltage thresholds, respectively. The time measurement starts
when the signal crosses the first trigger level - the upper or lower level depending on
the selected slope - and stops when the signal crosses the second level.
Suffix:
<m>
.
1..22
1..4: Indicates the trigger source: analog channel 1 to 4
5..22: not available
Parameters:
<Level> Range: -10 to 10
Increment: 1E-3
*RST: 0
Default unit: V
TRIGger:SLEW:SLOPe <Slope>
Sets the edge direction for the trigger.
Parameters:
<Slope> POSitive | NEGative | EITHer
*RST: POSitive
TRIGger:SLEW:RANGe <Condition>
Defines the time limits of the slew rate.
Waveform Setup