User manual

Remote Control Commands
R&S
®
Scope Rider RTH
208User Manual 1326.1578.02 ─ 04
LOGGer:SLOT:CLEar
Deletes the log data of a slot. The slot is defined using LOGGer:SLOT:CURRent.
Only possible while logging is stopped.
Usage: Event
12.7.2 Cursor in Logger Mode
12.7.2.1 Cursor Settings
LOGGer:CURSor<m>:STATe..........................................................................................208
LOGGer:CURSor<m>:TYPE........................................................................................... 208
LOGGer:CURSor<m>:SCPLing.......................................................................................208
LOGGer:CURSor<m>:COUPling..................................................................................... 209
LOGGer:CURSor<m>:SCReen....................................................................................... 209
LOGGer:CURSor<m>:STATe <Enabled>
Enables or disables the logger cursor measurement.
Suffix:
<m>
.
1..2
Parameters:
<Enabled> ON | OFF
*RST: OFF
LOGGer:CURSor<m>:TYPE <Value>
If data logging is running for more than 2 days and 7 hours, the logger compresses 4
logging values into a minimum, average and maximum value. The command sets the
measured crossing point between the cursor lines and the waveform.
For logging periods shorter than 2 days and 7 hours, tha command is not relevant.
Parameters:
<Value> MINimum | AVERage | MAXimum
*RST: AVERage
LOGGer:CURSor<m>:SCPLing <TrackScaling>
If ON, the position of the cursor lines is adjusted when the horizontal scale is changed.
If OFF, the cursor lines remain on their position on the display when the scaling is
changed.
Suffix:
<m>
.
1..2
Data Logging