User manual

Getting Started
R&S
®
Scope Rider RTH
32User Manual 1326.1578.02 ─ 04
Key Short press Long press
Open or close the "Mode", "File" or "Setup" dialog, respectively.
Outputs measurement documentation: saves a
screenshot, waveform data, results, logger
record, instrument settings, and/or text com-
ment. You can select the data for output.
Opens or closes the "Screen-
shot" dialog to configure the
documentation output.
All R&S RTH:
Only R&S RTH1004:
The effect depends on the channel state:
If the channel is off, the key switches the chan-
nel on and sets the focus. The key lights up.
If the channel is on but not in focus, the key
sets the focus. The key lights up.
Open or close the "Vertical"
dialog for the correspondent
channel to configure the chan-
nel settings.
Only R&S RTH1002: DMM starts or stops the meter measurements
(same as MODE = "Meter").
DMM REL enables or disables relative meter
measurements.
Opens or closes the "Meter"
dialog to configure the mea-
surements.
TIME and POS adjust the horizontal time scale and position of the trigger point.
RANGE and POS set the vertical scale (vertical sensitivity) and the vertical posi-
tion of the focused waveform (analog or channel, math or reference waveform).
SIGNAL OFF switches the focused waveform
off.
RUN STOP starts and stops the acquisition.
SETUP opens or closes the "Trigger" dialog to select the trigger type and adjust
the trigger settings.
Operating Basics