User manual

Data Logging
R&S
®
Scope Rider RTH
115User Manual 1326.1578.02 ─ 04
The logger cursor only allows you to set a "Cursor Value". You cannot define the cur-
sor "Type" and "Source" as you can in the "Scope" and "Mask" mode because these
settings are not relevant for logging.
Description of settings
Access: "Cursor" menu
Figure 6-3: Cursor settings
Enable
Enables or disables the cursor measurement.
Remote command:
LOGGer:CURSor<m>:STATe on page 208
Cursor Value
Sets the measured crossing point between the cursor lines and the waveform, see Fig-
ure 6-4. These settings only apply if data logging is running for more than 2 days and 7
hours. After this time, the logger compresses 4 logging values into a "Minimum", "Aver-
age" and "Maximum" value.
Analyzing Logged Data