User manual

Documenting Results
R&S
®
Scope Rider RTH
138User Manual 1326.1578.02 ─ 04
9 Documenting Results
The R&S RTH can store various data to files for further analysis and reporting:
●
Instrument Settings
●
Screenshots
●
Logger Records
9.1 Using USB Flash Drive
You can connect a USB flash drive on the right side of the instrument. If a USB flash
drive is connected, all screenshots and result data are written to this external device by
default. Instrument settings are usually saved on the instrument, but you can store
them to the USB flash drive as well.
1. To check the status of the USB flash drive, long-press the FILE key.
The connection status is shown on the top of the menu.
2. To check the the file system on the USB flash drive for errors, tap "Check USB
Drive".
3. To remove the USB flash drive from the instrument, tap "Eject USB Drive"
9.2 Instrument Settings
To repeat measurements or tests at different times or perform similar measurements
with different test data, you can save the used configuration settings for later use. Fur-
thermore, it can be helpful to refer to the configuration settings of a particular measure-
ment when analyzing the results. Therefore, you can easily save the complete mea-
surement configuration including the display settings.
The R&S RTH provides two ways to store the measurement configuration:
●
Save as fast setting
●
Save as saveset
Instrument Settings