User manual

Remote Control Commands
R&S
®
Scope Rider RTH
191User Manual 1326.1578.02 ─ 04
12.4.3 Cursor Measurements
● Cursor Settings..................................................................................................... 191
● Cursor Measurement Results............................................................................... 192
12.4.3.1 Cursor Settings
CURSor:STATe............................................................................................................. 191
CURSor:FUNCtion......................................................................................................... 191
CURSor:SOURce...........................................................................................................191
CURSor:COUPling.........................................................................................................191
CURSor:SCPLing...........................................................................................................192
CURSor:SCReen........................................................................................................... 192
CURSor:MEASurement<m>:TYPE.................................................................................. 192
CURSor:STATe <State>
Enables or disables the cursor measurement.
Parameters:
<State> ON | OFF
*RST: OFF
CURSor:FUNCtion <Type>
Defines the type of the cursor measurement.
Parameters:
<Type> VERTical | HORizontal | TRACking | MEASure
See Chapter 3.3.1, "Cursor Types and Results", on page 80.
*RST: VERTical
CURSor:SOURce <Source>
Defines the source on which the cursor measurement is performed. The source setting
is not relevant for the vertical cursor type.
Parameters:
<Source> C1 | C2 | C3 | C4 | M1 | D0 | D1 | D2 | D3 | D4 | D5 | D6 | D7
*RST: C1
CURSor:COUPling <Coupling>
Couples the cursor lines so that the distance between the two lines remains the same
if one cursor is moved.
Parameters:
<Coupling> ON | OFF
*RST: OFF
Waveform Analysis