User manual

Waveform Setup

R&S

Scope Rider RTH

44User Manual 1326.1578.02 ─ 04

Reference point

= Left

Reference point

= Middle

Reference point

= Right

t = 0

Horiz. position from

left ref. point (< 0)

Horiz. position from

middle ref. point (> 0)

Horiz. position from right ref. point (> 0)

Description of settings

Time Scale

Sets the time scale of the horizontal axis for all signals, in seconds per division. The

value is shown in the top information bar.

Increase the scale to see a longer part of the waveform. Decrease the scale to see the

signal in more detail. The scale has a point that remains fixed on the screen when the

scale value is changing - the reference point.

To set the time scale, you can also use the TIME keys.

Remote command:

TIMebase:SCALe on page 164

TIMebase:RANGe on page 165

Horizontal Position

Sets the horizontal position of the trigger point in relation to the reference point. The

trigger position is marked by a colored triangle at the top of the diagram.

You can set the trigger point even outside the diagram and analyze the signal some

time before or after the trigger. In this case, the trigger marker is shown on the left or

right side of the diagram.

To set the horizontal position, you can also use the POS keys.

Remote command:

TIMebase:HORizontal:POSition on page 165

Horizontal Setup