User manual

Waveform Analysis
R&S
®
Scope Rider RTH
82User Manual 1326.1578.02 ─ 04
If the measurement result is outside the measurement range and clipping occurs, the
results are marked with < (underflow) or > (overflow). Adjust the vertical scale to get
valid results.
●
CURSor:MEASurement<m>:RESult:ACTual? on page 194
●
CURSor:MEASurement<m>:RESult:LIMit? on page 194
3.3.2 Settings for Cursor Measurements
Access: "Cursor" menu
State
Enables or disables the cursor measurement.
Remote command:
CURSor:STATe on page 191
Type
Defines the type of the cursor measurement.
For details, see Chapter 3.3.1, "Cursor Types and Results", on page 80.
"Vertical"
Displays two vertical cursor lines and measures their timing parame-
ters.
"Horizontal"
Displays two horizontal cursor lines and measures their amplitude
parameters.
"Track"
Displays two vertical cursor lines and couples them to the source
waveform. The amplitude characteristcs and the time difference of
the crossing points are measured.
"Measure"
Displays two vertical cursor lines that define a gate for two simultane-
ous automatic measurements.
Cursor Measurements