User manual

Waveform Analysis
R&S
®
Scope Rider RTH
86User Manual 1326.1578.02 ─ 04
3.5 Reference Waveforms
To compare waveforms and analyze differences between waveforms, you can use a
reference waveform. You can also save reference waveforms and load them for further
use. The display of a reference waveform is independent from that of the source wave-
form; you can change the vertical scale and position
To create and save a reference waveform
1. Set up the waveform that will be the reference.
2. Open the "Ref" menu.
3. Select the "Source" waveform.
4. Select "Update".
The reference waveform is created, activated, and shown on top of the original
waveform.
5. You can change the vertical scale and position using the RANGE and POS keys.
6. To save the reference, select "Save".
7. Select the "File Type" (format BIN, XML, or CSV).
8. Select the "File Name" and enter the file name.
3.5.1 Settings for Reference Waveforms
Access: "Ref" menu
Source
Selects the waveform to be taken as reference waveform. Any active channel or math
waveform can be used.
Remote command:
REFCurve:SOURce on page 196
Reference Waveforms