User manual

Waveform Analysis
R&S
®
Scope Rider RTH
87User Manual 1326.1578.02 ─ 04
Update
Creates the reference waveform from the source waveform.
Remote command:
REFCurve:UPDate on page 196
State
Activates the waveform and displays it.
Remote command:
REFCurve:STATe on page 196
CALCulate:MATH:STATe on page 195
Vertical Position
Sets the vertical position of the reference waveform.
You can also tap the waveform label "R" to set the focus to the reference waveform,
and use the RANGE and POS keys to adjust the display.
Remote command:
REFCurve:POSition on page 197
Save / Load
Saves or loads a reference waveform. The default directory is C:/Users/<user>/
Rohde-Schwarz/RTH/ReferenceCurves.
Select the "File Type" (format BIN, XML, or CSV) and enter the "File Name". See also
Chapter 3.5.2, "Waveform Files", on page 87.
Remote command:
REFCurve:NAME on page 197
REFCurve:SAVE on page 197
REFCurve:OPEN on page 197
REFCurve:DELete on page 197
3.5.2 Waveform Files
Reference waveforms can be stored in XML, CSV, or BIN format.
If you want to reload reference waveforms on the instrument, save them in BIN or CSV
format. XML files cannot be reloaded.
Waveform data is saved in two files. One file contains the waveform data values and is
indicated by *Wfm.* in the file name. The second file contains the header data, for
example, time scale, vertical scale, vertical position, acquisition mode, and more.
Header data is required to reload the waveform from data, or to analyze the data val-
ues of the data file.
Reference Waveforms