Manualshelf

User manual

ManualsBrandsROHDE & SCHWARZ ManualsLaboratory Test EquipmentHandheld (scope-meter) RTH1052 500 MHz 500 null 10 Bit
131132133134135136137138139140
Multimeter Measurements
R&S
®
Scope Rider RTH
101User Manual 1326.1578.02 ─ 04
Figure 5-1: One-voltmeter-view
1 = Measurement state. Manual: running measurement
2 = Probe settings
3 = Minimum value and time stamp
4 = Average value
5 = Maximum value and time stamp
6 = Warning sign, shows up if the measured value is higher than 30 V
7 = Bar graph displaying the measured value
8 = Measurement source (input channel). Selected source is highlighted.
9 = Measurement type (AC, DC or AC+DC). Selected type is highlighted.
10 = Restarts the measurement and resets all values
11 = Activates or deactivates relative measurement
12 = On/Off-Switch to turn selected meter on or off
13 = Displayed voltmeter, indicated by highlighted number
The buttons at the bottom of the display offer the following quick settings:
●
Input Signal
●
Measure Type
●
Restart Test
●
Relative
Voltmeter (R&S RTH1004)