User manual

Multimeter Measurements
R&S
®
Scope Rider RTH
102User Manual 1326.1578.02 ─ 04
Figure 5-2: Four-voltmeter-view
1 = Channel measured by the voltmeter
2 = Bar graph displaying the measured value
3 = Channel range
Remote command:
●
METer<m>:READ? on page 205
●
METer<m>:FETCh? on page 206
In meter mode, the keys behave slightly different from scope mode:
●
The vertical RANGE and POS keys both adjust the range of the selected input
channel.
●
The MEAS key opens the "Meter" menu.
●
The following keys work as usual: FILE,
, , PRESET, AUTOSET, MODE,
BACK.
●
All other keys do not work.
Displaying voltmeters
► To switch to one-voltmeter-view, use one of the following methods:
● Tap the meter number as shown in Figure 5-2.
● Turn the wheel to select a voltmeter, and press the wheel button to open it.
► To view all 4 voltmeters, use one of the following methods:
● Tap the highlighted number of the opened voltmeter as shown in Figure 5-1.
● Press BACK.
Voltmeter (R&S
RTH1004)