User manual

Multimeter Measurements
R&S
®
Scope Rider RTH
105User Manual 1326.1578.02 ─ 04
Input Signal
Selects the channel which is measured by the selected meter.
Remote command:
METer<m>:SENSe:SOURce on page 205
Relative
Activates or deactivates relative measurement. If you activate this function, the cur-
rently measured value is taken as reference value. Instead of the bar graph, the refer-
ence value and the measured value are displayed (see Figure 5-4). You can also set a
desired value as reference value, see "Reference / Reference Manual" on page 105.
Figure 5-4: Relative measurement
1 = Reference value
2 = Measured value relative to reference value
Reference / Reference Manual
"Reference" activates or deactivates the manual reference value.
If active, enter the reference value in "Reference Manual".
Restart Test
Restarts the measurement.
Remote command:
RUN on page 166
STOP on page 166
RANGE / POS
In meter mode, the vertical RANGE and POS keys adjust the measurement range of
the selected channel.
Remote command:
METer<m>:SENSe:RANGe on page 205
5.2 Digital Multimeter (R&S RTH1002)
The hardware-based digital multimeter features various multimeter measurements.
Except for voltages, the DMM can also measure resistance, capacitance, temperature
and more.
In "Meter" mode, a separate self-alignment of the meter inputs is available, see Chap-
ter 10.2, "Selfalignment", on page 144.
Digital Multimeter (R&S RTH1002)