User manual

Multimeter Measurements
R&S
®
Scope Rider RTH
106User Manual 1326.1578.02 ─ 04
5.2.1 Accessing the Meter Mode
► There are several ways to start the multimeter mode:
● Press the DMM key.
● Press the MODE key, and select "Meter".
● To start relative measurements, press the DMM REL key.
The multimeter interface is displayed, and the measurement is started immediately.
5.2.2 Display and Control
The multimeter display shows detailed results and setup icons.
Figure 5-5: Display of the digital multimeter
1 = Measurement state. Manual: running measurement
2 = Measurement range
3 = Test lead connection including polarity
4 = Minimum value and timestamp
5 = Average value
6 = Maximum value and timestamp
Digital Multimeter (R&S RTH1002)