User manual
Data Logging
R&S
®
Scope Rider RTH
111User Manual 1326.1578.02 ─ 04
Figure 6-1: Logger display, view of all logged scope measurements
1 = Logged measurements
2 = Latest values of the logged measurements (depends on logging type and measurement type)
3 = Time basis
4 = Memory slot
5 = Recording time
6 = Start time
7 = Upper and lower scaling value of each measurement
8 = Time stamp of the left side of the display
Displaying logged measurements
1. To switch to one-log-view, use one of the following methods:
● Tap on one of the logged measurements as shown in Figure 6-1.
● Press the assigned CH key.
2. To view all logs, use one of the following methods:
● Tap the highlighted number of the opened log.
● Press the CH key of the opened log.
6.3 Logging Data
You can log up to four different scope measurements or meter measurements simulta-
neously.
Before you start the logging, set up and activate the measurements that you want to
log. See:
●
Chapter 3.2, "Automatic Measurements", on page 74
●
Chapter 5, "Multimeter Measurements", on page 100
Logging Data