User manual

Data Logging
R&S
®
Scope Rider RTH
112User Manual 1326.1578.02 ─ 04
1. Access the logger mode, see Chapter 6.1, "Accessing the Logger Mode",
on page 110.
2. Select the "Logger" menu.
3. If data logging is running, press RUN/STOP to stop the logging. The logged data is
stored automatically. You can only adjust the logger settings if logging is stopped.
4. Select the source that you want to log.
5. Select the sample rate.
6. Select the horizontal scale.
By default, the horizontal scale is set to "auto". In this case, all logged data are
always displayed, and the scaling is adjusted automatically when the amount of
data increases..
7. Select the slot, where the logged data will be stored.
8. To start logging, press the RUN STOP key.
When you stop logging, the logged data is stored automatically in the selected slot.
Each slot stores the data of a single logging period. If you use the slot a second
time, the stored data is overwritten.
6.4 Logger Settings
Access: "Logger" menu
Logger Settings