User manual

Data Logging
R&S
®
Scope Rider RTH
113User Manual 1326.1578.02 ─ 04
Source
Selects the logger source: "Scope" or "Meter".
Remote command:
LOGGer:SOURce on page 207
Sample Rate
Selects the number of log samples per second.
Remote command:
LOGGer:TIMebase:SRATe on page 207
Horizontal Scale
Selects the horizontal scale of the logged data.
The horizontal scale is set to "auto" by default. In this case, all logged data is always
displayed.
Remote command:
LOGGer:TIMebase:SCALe on page 207
Slot
Selects one of the 10 memory slots for storing the logged data.
If data is stored in a slot, the start time of the stored data is displayed in the menu. You
can change the slot during recording.
Remote command:
LOGGer:SLOT:CURRent on page 207
Load Slot
Loads the stored log data of the selected slot.
Only possible while logging is stopped.
Remote command:
LOGGer:SLOT:LOAD on page 207
Clear Slot
Deletes the log data of the selected slot.
Only possible while logging is stopped.
Remote command:
LOGGer:SLOT:CLEar on page 208
Clear All Slots
Deletes the log data of all slots.
Only possible while logging is stopped.
Remote command:
LOGGer:SLOT:CLEar on page 208
Logger Settings