User manual

ManualsBrandsROHDE & SCHWARZ ManualsLaboratory Test EquipmentHandheld (scope-meter) RTH1052 500 MHz 500 null 10 Bit

181

182

183

184

185

186

187

188

189

190

Network Connections

R&S

Scope Rider RTH

155User Manual 1326.1578.02 ─ 04

If the network supports DHCP, the DHCP server assigns these parameters. It is safe to

establish a connection to the LAN without any previous instrument configuration.

If DHCP is not supported, enter the address information manually (static address).

Note: Risk of network errors. Connection errors can affect the entire network. If your

network does not support DHCP, or if you disable DHCP, make sure to assign valid

address information before connecting the instrument to the LAN. To obtain a valid IP

address, subnet mask, and gateway, contact your network administrator.

MAC Address

Shows the media access control address (MAC address), a physical address and a

unique identifier of the instrument.

11.2 USB connection

The USB device connector is intended to connect a computer directly to the instru-

ment. You need a VISA communication tool installed on the computer to control the

instrument using remote commands.

1. Connect a USB cable to the USB mini-B connector on the right panel of the instru-

ment, and to a computer.

Press the key.

3. Select "USB/LAN".

4. Select "Interface" = "USB".

The instrument shows the connection status.

5. When the computer detects the connected instrument, the drivers are automatically

installed, and a message is displayed.

The drivers are IVI drivers

6. Open the Device Manager on the computer and check if the connected instrument

is shown.

11.3 Wireless LAN Connection (Option R&S RTH-K200)

Using the option R&S RTH-K200 , you can connect your instrument to portable devi-

ces. When connected, the waveform display and user interface of the R&S RTH are

directly available in the web browser. All settings can be changed in the browser, no

software installation is required.

There are two ways to connect via wireless LAN:

●

Usually, the R&S RTH is the access point and you set up connection on the porta-

ble device.

●

The R&S RTH is the client that connects to a router or access point.

Wireless LAN Connection (Option R&S RTH-K200)