User manual

Network Connections
R&S
®
Scope Rider RTH
156User Manual 1326.1578.02 ─ 04
To enable wireless LAN
1.
Press the key.
2. Tap "Wireless LAN".
3. Only for option R&S RTH-K200: Select the country, where you use the instrument.
The list contains all countries where the wireless LAN option has been approved.
You also can find the list in the data sheet.
4. Enable "Wireless State".
Now you can connect the instrument.
To use the instrument as access point
1. Select "Wireless Mode" = "Access Point" in the "Wireless LAN" menu.
2. If you connect for the first time, change the default "Passphrase". You can also
change the identifier of the instrument, the "SSID".
3. On your portable device, set up the connection to the instrument. Select the SSID
and enter the passphrase.
The detailed procedure is described in the documentation of your portable device.
To use the instrument as client
1. Select "Wireless Mode" = "Client" in the "Wireless LAN" menu.
2. Tap "Scan" for available wireless LAN routers and access points.
3. Select the "Network SSID" of the required router.
4. Enter the password of the required router in "Network Passphrase".
If the connection succeeded, "Connected" is enabled.
Alternatively, you can enter the DHCP or static IP address of the router to identify
it.
Description of settings
Wireless LAN Connection (Option R&S RTH-K200)