User manual

Remote Control Commands
R&S
®
Scope Rider RTH
161User Manual 1326.1578.02 ─ 04
CHANnel<m>:SCALe <Scale>
Sets the vertical scale (vertical sensitivity) of the indicated waveform.
Suffix:
<m>
.
1|2 (RTH1002) , 1..4 (RTH1004)
Parameters:
<Scale> Scale value, given in Volts per division
Range: 2E-3 to 100
Increment: 1E-3
*RST: 0.05
Default unit: V/div
CHANnel<m>:RANGe
<Range>
Sets the voltage range across the 8 vertical divisions of the diagram. Use the com-
mand alternatively to CHANnel<m>:SCALe.
Suffix:
<m>
.
1|2 (RTH1002) , 1..4 (RTH1004)
Parameters:
<Range> Voltage range value
Range: 0 to 800E+3
Increment: 10E-6
*RST: 0
Default unit: V
CHANnel<m>:PROBe <ProbeSettings>
Sets the attenuation factor of the connected probe. The vertical scaling and measured
values are multiplied by this factor so that the displayed values are equal to the actual
signal values.
Make sure to set the attenuation factor on the instrument according to the probe being
used. Otherwise, the measurement results do not reflect the actual voltage level, and
you might misjudge the actual risk.
Suffix:
<m>
.
1|2 (RTH1002) , 1..4 (RTH1004)
Waveform Setup