User manual

Remote Control Commands
R&S
®
Scope Rider RTH
165User Manual 1326.1578.02 ─ 04
TIMebase:RANGe <AcquisitionTime>
Sets the acquisition time, the timerange across the 10 horizontal divisions of the dia-
gram. Use the command alternatively to TIMebase:SCALe.
Parameters:
<AcquisitionTime> Range: 10E-9 to 5000
Increment: Steps 1, 2, 5 (1, 2, 5, 10, 20, 50, 100, 200, 500...)
*RST: 1E-6
Default unit: s
TIMebase:HORizontal:POSition <Position>
Sets the horizontal position of the trigger point in relation to the reference point.
See also: "Horizontal Position" on page 44
Parameters:
<Position> Range: Depends on the time scale, see table below.
Increment: 0.1
*RST: 0
Default unit: s
Time scale Min./max. horizontal position
1 ns/div to 100 µs/div ±2 s
200 µs/div to 2 s/div Time scale * 20000
5 s/div – 500 s/div 100000 s
TIMebase:REFerence <ReferencePoint>
Defines the time reference point in the diagram.
Parameters:
<ReferencePoint> Position of the reference point in percent of the screen width.
Available values are:
10: on the left side of the screen
50: in the middle of the screen
90: on the right side
*RST: 50
Default unit: %
ACQuire:POINts:ARATe?
Returns the number of recorded analog waveform points per second.
Waveform Setup