User manual

Remote Control Commands
R&S
®
Scope Rider RTH
182User Manual 1326.1578.02 ─ 04
Parameters:
<HoldTime> Range: -124E-9 to 124E-9
Increment: 1E-9
*RST: 1E-9
Default unit: s
TRIGger:DATatoclock:STIMe <SetupTime>
Sets the minimum time before the clock edge while the data signal must stay steady.
The setup time can be negative. In this case, the hold time has to be positive. The
setup time is defined by TRIGger:DATatoclock:HTIMe.
Parameters:
<SetupTime> Range: -124E-9 to 124E-9
Increment: 1E-9
*RST: 1E-9
Default unit: s
12.3.5.10 Serial Pattern Trigger
TRIGger:SPATtern:DSOurce[:VALue].............................................................................. 182
TRIGger:SPATtern:CSOurce[:VALue].............................................................................. 182
TRIGger:SPATtern:CSOurce:EDGE.................................................................................182
TRIGger:SPATtern:CSOurce:FIRStedge.......................................................................... 183
TRIGger:SPATtern:ORDer..............................................................................................183
TRIGger:SPATtern:PATTern........................................................................................... 183
TRIGger:SPATtern:DSOurce[:VALue] <Source>
Selects the input channel of the data signal.
Parameters:
<Source> C1 | C2 | C3 | C4 | D0 | D1 | D2 | D3 | D4 | D5 | D6 | D7
*RST: C1
TRIGger:SPATtern:CSOurce[:VALue] <Source>
Sets the input channel of the clock signal.
Parameters:
<Source> C1 | C2 | C3 | C4 | D0 | D1 | D2 | D3 | D4 | D5 | D6 | D7
*RST: C1
TRIGger:SPATtern:CSOurce:EDGE <Slope>
Sets the edge at which the data value is sampled.
Waveform Setup