User manual

Remote Control Commands
R&S
®
Scope Rider RTH
186User Manual 1326.1578.02 ─ 04
TRIGger:WINDow:DELTa <Tolerance>
Sets a range Δt to the specified width, which is defined using TRIGger:WINDow:
WIDTh.
Parameters:
<Tolerance> Range: 0 to 5000
Increment: 500E-12
*RST: 0
Default unit: s
12.3.5.13 Interval Trigger
TRIGger:INTerval:SLOPe............................................................................................... 186
TRIGger:INTerval:RANGe...............................................................................................186
TRIGger:INTerval:WIDTh................................................................................................187
TRIGger:INTerval:DELTa................................................................................................187
TRIGger:INTerval:SLOPe <Slope>
Sets the edge direction for the trigger. You can analyze the inteval between positive
edges or between negative edges.
Parameters:
<Slope> POSitive | NEGative
*RST: POSitive
TRIGger:INTerval:RANGe <Condition>
Defines how the time range of an interval is defined.
Parameters:
<Condition> LONGer | SHORter | EQUal | NEQual | WITHin | OUTSide
LONGer | SHORter
Triggers on intervals shorter or longer than an interval that is set
using TRIGger:INTerval:WIDTh.
EQUal | NEQual
Triggers on intervals equal or not equal a given interval width
that is set using TRIGger:INTerval:WIDTh. In addition, a tol-
erance can be set around the specified width using TRIGger:
INTerval:DELTa.
WITHin | OUTSide
Triggers on intervals inside or outside a given range. The range
is set using ... and ....
*RST:
LONGer
Waveform Setup