User manual

Remote Control Commands
R&S
®
Scope Rider RTH
187User Manual 1326.1578.02 ─ 04
TRIGger:INTerval:WIDTh <Duration>
Sets the time between two pulses for comparisons EQUal, UNEQual, SHORter, and
LONGer.
Parameters:
<Duration> Range: 800E-12 to 10000
Increment: 100E-9
*RST: 5E-9
Default unit: s
TRIGger:INTerval:DELTa <Tolerance>
Sets a range Δt to the specified width, which is defined using TRIGger:INTerval:
WIDTh.
Parameters:
<Tolerance> Range: 0 to 5000
Increment: 500E-12
*RST: 0
Default unit: s
12.4 Waveform Analysis
12.4.1 Zoom
See also Chapter 3.1, "Zoom", on page 72.
ZOOM:ENABle.............................................................................................................. 187
ZOOM:SCALe............................................................................................................... 187
ZOOM:POSition.............................................................................................................188
ZOOM:ENABle <Enabled>
Enables or disables the zoom.
Parameters:
<Enabled> ON | OFF
*RST: OFF
ZOOM:SCALe <Scale>
Sets the time scale of the zoomed waveform.
Depending on the recording time not all horizontal scales are available. This is due to
the fact that, the zoom is always displaying a complete curve.
Waveform Analysis