User manual

Remote Control Commands
R&S
®
Scope Rider RTH
189User Manual 1326.1578.02 ─ 04
The sources can be any active input signal, math or reference waveform. Available
source waveforms depend on the measurement type, see Chapter 3.2.2, "Measure-
ment Types", on page 74.
Suffix:
<m>
.
1..4
Parameters:
<Source> C1 | C2 | C3 | C4 | M1 | R | D0 | D1 | D2 | D3 | D4 | D5 | D6 | D7
<Source2> C1 | C2 | C3 | C4 | M1 | R | D0 | D1 | D2 | D3 | D4 | D5 | D6 | D7
MEASurement<m>:TYPE
<Type>
Selects the measurement type. For a detailed description, see Chapter 3.2.2, "Mea-
surement Types", on page 74.
Suffix:
<m>
.
1..4
Parameters:
<Type> PERiod | FREQuency | RTIMe | FTIMe | PPULse | NPULse |
PDCYcle | NDCYcle | DELay | PHASe | MEAN | RMS | CRESt |
STDDev | MINimum | MAXimum | PKPK | BASelevel |
TOPLevel | AMPLitude | OVRShoot | PREShoot | AC | DC |
ACDC | PPCount | NPCount | RECount | FECount | PWRP |
PWRS | PWRQ | PWRFactor
*RST: MINimum
RTIMe Rise time PREShoot Preshoot
FTIMe Fall time PPCount Positive pulse count
PPULse Positive pulse width NPCount Negative pulse count
NPULse Negative pulse width RECount Rising edge count
PDCYcle Positive duty cycle FECount Falling edge count
NDCYcle Negative duty cycle PWRP Active power
STDDev Standard deviation PWRS Apparent power
PKPK Peak to peak PWRQ Reactive power
OVRShoot Overshoot PWRFactor Power factor
MEASurement<m>:AOFF
Disables all active measurements.
Suffix:
<m>
.
1..4
The suffix is irrelevant.
Usage: Event
Waveform Analysis